
Balluff Inductive sensor - Balluff Vietnam | ANS Vietnam
Giá bán: Liên hệ
Hãng sản xuất: Chua phan loai
Danh mục: Balluff
Inductive sensor
Order Code: BES00HM
BES 516-3006-G-E4-C-PU-02
Keyfeatures
Size | M05 |
---|---|
Connection | Cable, 2m, PUR |
Switching output / function | NPN/Normally open (NO) |
Operating voltage | 10...30 V DC |
Special properties | Miniature |
Mechanical installation condition | Flush (shielded) |
Rated operating distance Sn | 1,5 mm |
General attributes
Ready delay tv max. | 25 ms |
---|---|
Utilisation category | DC 13 |
Switching freq. f max. | 3000 Hz |
Temp. drift max. (% of Sr) | 10% |
Repeat accur. R max. (% of Sr) | 5 % |
Power-on indicator | No |
Basic standard | IEC 60947-5-2 |
Function indicator | Yes |
Short-circuit protected | Yes |
Degree of protection as per IEC 60529 | IP67 |
Protected against polarity reversal | Yes |
Protected against reverse connection | Yes |
Additional text | The sensor is functional again after the overload has been eliminated.<br />Embeddable: See installation notes for inductive sensors with extended switching distance 825357.<br />EMC: EMC-protection circuitry required, see document 825345. IVW: 2,2 |
Electrical attributes
Output resistance Ra | Open collector |
---|---|
Rated operating voltage Ue DC | 24 |
Effective operating current Ie | 100 mA |
Rated insulation voltage Ui | 75 DC |
Rated short circuit current | 100 A |
Electrical version | DC, direct current |
Hysteresis H max. (in % of Sr) | 15 % |
Minimum operating current Im | 0 mA |
Load capacitance max. (at Ue) | 0,2 µF |
No-load current Io damped | 10 mA |
No-load current Io undamped | 3 mA |
Off-state current Ir max. | 80 µA |
Ripple max. (% of Ue) | 10 % |
Switching output | NPN |
Switching function | Normally open (NO) |
Voltage drop static max. | 3 V |
Principle of operation | Inductive |
Operating voltage | 10...30 V DC |
Mechanical attributes
Ambient temperature | -25...70 °C |
---|---|
Number of conductors | 3 |
Tightening torque max. | 1 Nm |
Assured operating distance Sa | 0...1,2 mm |
Cable short designation | Li9Y11Y |
Cable length | 2 m |
Conductor cross-section | 0.14 mm² |
Eff. switching distance Sr | 1,5 mm |
Shock rating | Shock, half-sinus, 30 gn, 11ms |
Vibration rating | 55 Hz, 1 mm ampl., 3x30 min |
Degree of contamination | 3 |
Sensing surface material | PBT |
Housing material | Stainless steel |
Cable jacket material | PUR |
Cable diameter D max. | 3 |
Tolerance Sr | ±10 % |